Quicksilver Audio V4 Mono Amplifier
Operating Instructions
Thank you for purchasing the Quicksilver Audio V4 Mono Amplifiers. These amplifiers have been
engineered to have a very wide bandwidth, extremely low distortion and superior dynamic range.
The output transformer used in this amplifier is based on the best designs of the past but uses superior new
materials to achieve a very high level of performance. The high frequency characteristics of this transformer
are so stable that many different output tubes may be used without the need for circuit changes or
compensation adjustments.
This is an all tube design and uses no circuit boards or transistors.
PLACEMENT
TheV4MonoAmplifiersshouldhaveatleast6inchesofventilationspaceoneithersideandatleast
6 inches above them. If this is not possible, then use a fan for cooling.
SPEAKER CONNECTION
Five-way binding posts are used for speaker connection. For better sonic performance, we
recommend using the screw-down part of the post rather than banana plugs to connect your
speaker wire. Make sure the ends of the speaker leads do not touch each other. The rating on the
back of your speaker system will determine whether you use the 4 or 8 ohm tap for the positive
lead. Connect the negative or ground to the black post marked C.
IEC connector
Input
100K
fuse
C
8
4
4 amp
SYSTEM GROUNDING
At least one component of your system should always be grounded. Your Mono Amplifiers
come with three pronged grounded AC plugs. In some systems, where the preamp is also
grounded, agroundloopmayappearasalowlevelhum. UsinganadaptorontheACplugofeach
amplifier, to lift the ground, will solve this problem.
4 AMP SLO-BLO FUSE
Standard fuse value must not be exceeded. If a fuse blows, replace and check output tube bias. If
there is a large change in any tube, then that tube is probably damaged. If the bias has not changed
then the cause of the fuse blowing may be due to other problems, such as poor system grounding,
unstable preamp, shorted speaker, etc. Interchanging the amps between channels will help
localize the problem to either the system or the amplifier.
Quicksilver Audio V4 Mono Amplifier
SPECIFICATIONS
Power Output
120 watts into 4 or 8 ohms
from 22 Hz to 40 KHz
18 Hz to 80 KHz
180 watts at 1 KHz
1.5 volts
Power Bandwidth
Peak Power
Input Sensitivity
Input Impedance
100 K ohms
Tube Complement
1 - 12FQ7 input
1 - 12BH7 or 12FQ7 driver
2 - KT88 outputs
Dimensions
Finish
7 7/8” high x 13 3/4“ deep
x 16 3/4” wide
Nickel chassis
Carbide black capacitor and transformer cover
Weight
Warranty
51 lbs.
3 years parts and labor
Tubes 90 days
WARRANTY
Quicksilver Audio warranties your amplifiers for a period of 3 years from the date of purchase
(90 days on tubes.) Parts and labor are provided free of charge as long as the failure was not
caused by misuse, accident or negligence. Shipping to the factory is not included.
Retain at least one packing carton in case a unit needs to be returned for service.
Quicksilver Audio
11880 Upham Street, Unit E
Broomfield, CO 80020
(303) 469-0024 / Fax 469-0234
www.quicksilveraudio.com
|