®
SS5723/SS5729
SS5723L/SS5729L
Series Sun Shroud
nstallation/Operation
Manual C1419M (6/95)
1.0 WARNINGS
3.0 INSTALLATION
Prior to installation and use of this product, the follow-
ing WARNINGS should be observed.
To install the sun shroud, perform the following steps:
NOTE: Use the four (4) 10-32 x .375 Phillips
head screws and nylon washers from the en-
closure assembly.
1. InstallationandservicingshouldonlybedonebyQuali-
fied Service Personnel and conform to all Local codes.
2. Please thoroughly familiarize yourself with the
information in this manual prior to installation.
1. Unlatch the enclosure lid and raise.
2. Remove the four (4) 10-32 screws from the enclo-
sure lid (see diagram above).
2.0 SCOPE
The information contained within this manual covers
the SS5723, SS5729, SSS723L and SS5729L Sun
Shroud installation.
3. Align the screw holes in the sun shroud and enclo-
sure lid.
4. Install the screws as shown in the diagram above.
2.1 DESCRIPTION
The Sun Shrouds are designed for use with the EH5723L
and EH5729L Legacy® Series enclosures. The sun
shroud protects the enclosure form the direct rays of
the sun and reduces the internal temperature by approxi-
mately 10° to 15°F (-12.2° to -9.4°C) .
Pelco • 3500 Pelco Way, Clovis, CA 93612-5699 • USA • (800) 289-9100 or (1-559) 292-1981
FAX (800) 289-9150 or (1-559) 292-3827
International customers call (1-559) 292-1981 or FAX (1-559) 348-1120
|